BusMaintenance
Please Login
BusMaintenance

Questions and Answers for School Bus Maintenance
 
HomeHome  RegisterRegister  Log in  

Share | 
 

 How to use the Transmission Flusher

View previous topic View next topic Go down 
AuthorMessage
b1



Posts : 56
Join date : 2016-04-07

PostSubject: How to use the Transmission Flusher   Tue Apr 19, 2016 10:22 am

Transmission Flusher Instructions

1) Connect Black hose from pump to cooler return hose.
2) Connect the other Black hose to the cooler input and the other end goes into the bucket.
3) The Clear hose is the supply line and stays in the bucket.
4) Fill the bucket with clean transmission fluid half full.
5) Turn on pump and run for ½ hour.
6) Make sure that fluid is returning to bucket. If it is not the cooler is plugged and will need to be replaced.
7) Reverse the Black hoses and run again for ½ hour.
Cool After 1 hour of total flushing you are finished. Shut off the pump and remove the hoses.
9) Install your transmission.
10) Replace filter on flusher every flush.
11) Part number HF6057
12) Use ½ pipe for AT545 and use other fittings for 2000 Trans. Other adapters for smaller transmissions see Tim from Kimball Midwest.
13) Any questions call Don Bannerman 708-757-3010

Back to top Go down
 
How to use the Transmission Flusher
View previous topic View next topic Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
BusMaintenance :: Bus Maintenance :: Procedures-
Jump to: